1.25" Thread Over Install
1.25" Thread Over P-trap Install
Thread Over measure, fit and install
- Kit includes:
-
- 30” flexible hose
- P-trap loop with depth tab
- Threaded adapter
- Easy tighten hose clamp
- Only tool required is a pair of scissors
- Simple Drain fits both 1.5” and 1.25” tailpipe sizes
- Not include: SAE size 28 hose clamp
- Measure, fit and install:
-
- Measure your hose length by installing the simple drain 1.5” diameter smooth cuff end over the 1.25” threaded waste line
- Loosely tighten separately purchased hose clamp with screwdriver
-
- Clamp will be removed after measuring.
- Connect the trap loop to form the p-trap shape by lining it up level with the bottom of waste line and making the hose follow the edge of the depth tab
- Place hose next to tailpipe and note the trimming location. allow for at least 5 ribs to go over tailpipe so you can recut or adjust later if necessary
- With a sharp pair of scissors, trim in the valley of hose at the required hose length
- Cut should be trimmed cleanly across valley of hose
- Reconnect the simple drain 1.5” diameter smooth hose cuff end over 1.25” threaded waste line and tighten extra hose clamp with screwdriver
- Connect other end of hose to tailpipe with hose clamp by tightening it in the valley of the last rib
- Connect trap loop to form P-trap shape then use the depth tab to form a proper trap shape
(see diagram below)
- Run water, check for leaks, and adjust as needed