INSTALLATION VIDEO

What's in the kit:

• 30” flexible hose
• P-trap loop with depth tab
• Threaded adapter
• Easy tighten hose clamp 
• Only tool required is a pair of scissors
• Simple Drain fits both  1.5” and 1.25” tailpipe sizes

Measure, fit and install:

• Push hose over tailpipe then roughly make P-trap shape
• Connect trap loop and use depth gauge to properly size the trap
• Add 3 ribs from measurement in case recutting is required
• With a pair of sharp scissors trim in the valley of hose
• Connect trimmed hose to waste line adapter
• Hose fits snugly be sure to pop into place if needed, should rotate easy
• Thread adapter onto waste line by hand until tight
• Slide clamp and hose over tailpipe than tighten
• Connect trap loop to form P-trap and measure trap depth with tab so hose is tight to its edges 
• (see diagram below)
  
• Adjust the trap loop as needed to form the perfect P-trap
• Trap must follow edge of depth tab with loop level to the bottom of waste line
• Run water, check for leaks, and adjust as needed